HBK T210 - Page 25

23
T210
SPECIFICATIONS
Type T210
Nominal (rated) torque M
nom
2001005020105210.5Nm
Calibration signal %vC 50
Load resistance
Frequency output (differential)
Voltage output
Ω
kΩ
≥100
≥100
Longterm drift over 48h at reference
temperature
Frequency output
Voltage output
%
%
<005
<0.5
Measurement frequency range, -3db kHz 1
Residual ripple (voltage output) mV
SS
<100
Group delay ms <1
Maximum modulation range
Frequency output
Voltage output
kHz
V
4.4 … 15.6 (switch-on process: approx. 0)
-11.2 … +11.2 (switch-on process:
approx. -14)
Resolution
Frequency output
Voltage output
Hz
mV
0.5 at 10 kHz
0.5
Energy supply
Nominal (rated) supply voltage (safety extra
low voltage (SELV))
V DC 10…30
Calibration signal triggering V 3 … 30
Current consumption in measuring mode A <0.2 (at U
b12V
)
Nominal (rated) power consumption W <2.5 (in the range of the nominal (rated)
supply voltage)
Permissible residual ripple of supply voltage mV
SS
400
Measurement system for rotational speed/angle of rotation
Measurement system Optical
Pulses per revolution n 512
Output signal V 5(asymmetrical), two square wave
signals, shifted by approx. 90°
Minimum rotational speed for sufficient
pulse stability
rpm 0
Load resistance Ω >200
Group delay μs 1.5