HBM DMP41 - Table of Contents; Content

Content
DMP41 A03470_07_E00_00 HBM: public 3
Content
Content 3.....................................................................................
1 Safety instructions 7....................................................................
2 Symbols on the instrument 13............................................................
3 Introduction 15..........................................................................
3.1 Document information 15..............................................................
3.2 The markings used in this document 17..................................................
3.3 Scope of supply 18....................................................................
3.4 Device overview 19...................................................................
3.4.1 Front of device 21.............................................................
3.4.2 Back of device 22.............................................................
3.5 Principle of operation 24...............................................................
3.6 Preparation and connection 24..........................................................
4 Electrical connections 25.................................................................
4.1 Mains connection 25..................................................................
4.2 Transducer connection 26..............................................................
4.2.1 Connection options 27.........................................................
4.2.2 Full bridge strain gages 28......................................................
4.2.3 Temperature sensors 30........................................................
4.2.4 TID (Transducer Identification) 31................................................
4.3 Inputs and outputs, remote controls 33...................................................
4.4 PC connection 35.....................................................................
4.5 Synchronization 39....................................................................
5 Starting up 43............................................................................
5.1 Switching on 43.......................................................................
5.2 Installing the operating software: 45.....................................................
5.3 Important information before measurement 46............................................