Page
34
(r~=wp----=a:-3
PLATE
COIL
\u
Detail
4-5J
Refer to Detail 4-5J for the following steps.
the 15/10 plate coil
(#40-968) with the silver
plated strip located
as
shown.
(L.)
Place the open end of the coil tubing over the wire
projecting from lug 1 of the 80120 plate coil. Form
the solder lug so the coil tubing will butt snugly
against
it.
(A
Connect the tab on the coil to hole DA in the plate
coil bracket. Use 6-32 x
114" hardware.
(
1
Solder the coil tubing and the wire lead from the
switch wafer to lug 1 of the 80120 plate coil. Make
sure the end of the tubing
is
against the solder lug and
that this connection
is
well soldered.
(
f
1
Connect the free end of the silver plated strip to lug 2
of wafer
2
of switch
CZ.
Flex the end of the strip and
place it between the switch lugs as shown in the inset
drawing of the Detail
6-21.
4'
To Next Page
Loading...
