Heathkit SB-220 - Page 46

Page 38
PANEL
Detail 4-6D
J
transformer to insure approximately 1 I1 6" clearance
( 1 Adjust the position of the filament and bias ( Refer to Detail 4-6D and install the left side panel
(#203-6461. Use 6-32 x 318" phillips hardware at EF.
between the transformer end bell and any connections
Use
#6 x 318" sheet metal screws at EJ, EK, EL, EN,
to the lugs of switch EU.
EP, and ER.