m)=+:---+=wJ
Page
39
,
.
Detail 4-6E
PERFORATED
n
SMOOTH EDGE
FAN
Detail 4-6F
(4
Refer to Detail 4-6F and locate the perforated fan
cover (#205-874) and the rear panel (#203-644). The
I
(
J
Refer to Detail 46E and mount the
HV
transformer.
edges of the fan cover are smooth on one side and
Position the wires from the end bell so they are above
sharp on the other. Before placing the sharp edge
grommet Y. Insert all leads except the red and the
against the rear panel, check the two offcenter holes
redlyellow leads down through grommet
Y.
Use an
(FK and FJ) which, if viewed as shown in the Detail,
8-32 x 318" screw,
a
112" flat washer,
a
#8 solder lug
must
be
closest to the bottom left-hand comer.
and an 8-32 nut at AD. At BX, BY and
BZ,
use 8-32 x
318" hardware with a 112" flat washer at each
ldcaion. Before you tighten the hardware, make sure
(
d
Fasten the perforated fan cover to the rear panel with
the transformer end bell does not protrude beyond the
6-32 hardware. The sharp edge of the fan cover should
chassis rear apron.
be
turned toward the rear panel.
To Next Page
Loading...
