I
,Esa-*:-*=*:*%,@
Page 41
Refer to Pictorial 4-7 (fold-out from Page 43) for the
CAPACITOR BANK
following Steps.
I
BRACKET ASSEMBLY
\
(
d
Refer to Detail 4-7A and mount the circuit board
assembly on the capacitor bank bracket. Use 6-32
x
114" screws, 6-32
x
314" tapped metal spacers, 6-32
x
314" tapped phenolic spacers, 112" flat washers, and
6-32
x
318" flat head screws. Note that the diodes,
and the phenolic spacers, are along the lower edge of
Ll
the circuit board.
(
Refer to Detail 4-78 and mount the capacitor bank
bracket with one spade bolt entering each of holes BR,
BS, BT, and BU. Use #6 lockwashers and 6-32 nuts
only on spade bolts BR, BS, and BU. Leave the nuts
flush with the ends of the spade bolts.
)
Mount a 5-lug terminal strip (#431-42) on spade bolt
J
BT. Use two #6 lockwashers and a 6-32 nut. Leave the
face of the nut flush with the end of the spade bolt.
#6
LOCKWASHER
Detail
4-7B
To Next Page
Loading...
