Page 42
CAPACITOR MOUNTING
INSULATOR
200pF
ELECTROLYT lC
CAPACITOR
CAPACITOR MOUNTING
INSULATOR
Refer to Detail 4-7C for the steps covering the capacitor
bank assembly.
(
t/
Part A: Assemble four capacitor sections. each
composed of two capacitor mounting insulators,
(#75-125) and two 200
,vF
electrolytic capacitors
(#25-224).
(
t)
Part B: Stack three capacitor sections in the capacitor
bank bracket. Then
lift
up the top section to the top
of the bracket.
I
d
Pan C: Insert the fourth capacitor section into the
vacated space in the bracket.
(
)
Part D: Align the capacitor lugs and the
+
polarity
markings as shown. Then push the capacitors snugly
against the fish paper and tighten the spade bolt nuts
on the bottom of the chassis just to the point where
you can no longer rotate the capacitors with your
fingers. Do not overtighten. Note the position of the
terminal strip mounting foot in Detail 4-7B.
Detail 4-7D
Refer to Detail 4-7D and cut four pieces of bare wire
1-518" long and one piece 1-318" long. Bend down
118" at one end of each. These wires will be used in
the capacitor bank wiring.
J
( )
Cut four pieces of small black sleeving 314" long for
use in wiring the capacitor bank.
LNOTE
VAR
IA~CE
IN POLARITY MARKINGS
Detail 4-7C
To Next Page
Loading...
