Heatmiser Touch Series - Removing Accessories

17
Removing Accessories
Pair/Reset
button
Pair/Reset
button
LED Indicator
Window/Door Wireless Contact Sensor Wireless Air Sensor
Touch Series
There are two ways to remove an accessory from the Touch Carbon thermostat.
On the Sensor/Switch
• Press and hold down the pairing/reset button for 15 seconds on the
‘Sensor/Switch’. LED indicator will ash 3 times to conrm reset.
At this point the ‘Sensor/Contact’ will notify the Touch Carbon that it has left,
and will automatically be removed from the ‘Accessory Menu’.
On the Touch Carbon thermostat
• Follow the steps on page 16 to enter the accessory menu.
• Press the ‘Up/Down’ arrow keys to view the accessory that will be deleted........
• Press and hold down the ‘DONE’ button for 10 seconds until the sensor
disappears from the menu .........................................................................................................
Note: You will also need to reset the sensor at this point.