5
Installation Procedure
Do
Don’t
Touch Series
Mount the Thermostat at eye level.
Read the instructions fully so you get the best from our product.
Do not install near to a direct heat source as this will aect functionality.
Do not push hard on the LCD screen as this may cause irreparable damage.
This thermostat is designed to be ush mounted and requires a back box of 35mm
(minimum depth) to be sunk into the wall prior to installation.
Step 1
Using a small screwdriver, slightly loosen the screw from the bottom face of the
thermostat. You can then carefully separate the front half from the back plate.
Step 2
Place the Thermostat LCD front plate somewhere safe.
Terminate the Thermostat as shown in the diagrams on page 32-35 of this booklet.
Step 3
Screw the Thermostat back plate securely into the back box.
Step 4
Replace the front of the thermostat onto the back plate, by locating the pins in the
socket then insert the top edge rst. Now push in the bottom edge, securing it in
place with the retaining screw.
To Next Page
Loading...
