Heatmiser Touch Series - Pairing Accessories

14
Model: Touch Carbon
Pairing Accessories
Wireless Air Sensor. Door/Window - Wireless Contact Sensor
(Not available in Time Clock mode).
You can pair a total of 16 accessories to a single Touch Carbon thermostat.
Wireless Air Sensor
Once a remote sensor is added, the Touch Carbon will automatically
display an average temperature between the ‘Wireless Air Sensor’ and the
on-board sensor inside the thermostat. Averaging will also be calculated
between multiple Air Sensors.
Window/Door Wireless Contact Sensor
If any one of the ‘Window/Door’ contacts is broken, the Touch Carbon
thermostat will be alerted and will activate ‘Frost Protection’ mode.
The display will now show the icon (right) to indicate a window or door has
been opened. Heating will not resume while this icon remains on screen.
Pairing the Air Sensor and Window/Door Contact.
• Press and hold the key for 3 seconds to turn o the display ...........................
• Press the ‘Setup’ key.....................................................................................................................
• Press ‘Down’ key until you see the letter ‘P’ displayed at the top of the
screen then press ‘NEXT’ ..................................................................................................................