Heatmiser Touch - Optional Settings - Feature Table

22
01
02
03
04
05
06
07
08
09
10
11
12
01
05
07
03
FEATURE
Temperature Format
Switching Differential
Frost Protect
Frost Protection Temperature
Output Delay
Communications ID No.
Up/Down Temperature Limit
Sensor Selection
Floor Temperature Limit
Optimum Start
Rate of Change
Program Mode
Temperature Format
Output Delay
Up/Down Temperature Limit
Frost Protect
DESCRIPTION
00 = °C, 01 = °F (°C = Default)
0.5° - 03°C (1.0°C = Default)
00 = Disabled, 01 = Enabled (01 = Default)
07° - 17°C (12°C = Default)
Enter Value: 00 - 15 Minutes (00 = Default)
Not used on this model.
00° - 10°C (00 = Default)
00 = Built in sensor
01 = Remote air sensor
Not available on this model
00 = Disabled (Default)
01 = 01hr, 02 = 02hr, 03 = 03hr
Minutes to raise by 1°C
00 = Non-Programmable
01 = 5/2 Day Programming
02 = 7 Day Programming
00 = °C, 01 = °F (°C = Default)
En
ter Value: 00 - 15 Minutes (00 = Default)
00
°
- 10
°
C (00 = Default)
00 = Disabled, 01 = Enabled (01 = Default)
SETTING
09
11
Floor Temperature Limit
Rate of Change
Not available on this model
Minutes to raise by 1
°
C
Optional Settings - Feature Table
Model: Touch