!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!IPCAM User Manual
- 24 -
! If your router has the Virtual Map function.Enter router setting page,add IPCAM’s IP
and port to the Virtual map list.
3.6 How to use DDNS
When use ADSL, the IP Camera will connect to the Internet through ADSL automatically.
For each ADSL reconnection,ISP will re-assign a new IP address for the IP Camera to
facilitate the access. DDNS(
Dynamic Domain Name Server
) can map the dynamic IP
address of an IP Camera to a fixed domain name.Therefore,we can access the IP
Camera by the fixed domain name whether the IP address changes or not. The IP
address is not necessary when you using the DDNS via the domain name to find your
network.
1) Go to the website which Provides free domain name,register and apply a free domain
name. such as
http://www.dyndns.com/(details:4.1.6 ).
2) login the Camera homepage as Administration and enter”DDNS Service
Settings”page input the name, password and Host(details:
2.5.3) .Then click <SUBMIT>
and reboot Device.
3) Re-login the Camera homepage and enter”DDNS Service Settings”page to check the
DDNS Status is DynDns Succeed or not.
4) Enter”UPnP Settings”page,the UPnP Status should be UPnP Succeed.If the status is
not Succeed,you may enter “Basic Network Settings” page to change Http Port (details:
2.5.5). Then click <SUBMIT> and reboot Device.
5) Re-login the Camera homepage to check and make sure the DDNS Status and UPnP
Status is Succeed.
6) You only need to enter the domain name(domain name+Port number
http://ipcam.kicks-ass.net:81/) in the IE address bar ,the browser will visit the IP Camera.
Wait for several minutes and the IP Camera will dial up to access the Internet
automatically, and the communication with the DDNS server is established successfully.
In the way, the user can access the IP Camera from a WAN by using the DDNS domain
name.
If the gateway settings and DDNS settings have been completed,ener the DDNS dynamic
domain name(for example,
http://ipcam.vicp.net/,do not add www.) in the address bar of
the IE to access the IP Camera.If multiple IP Cameras are connected to the same
router,enter DDNS dynamic domain + port number(for example, http://ipcam.vicp.net:85/)
in the address bar of the IE to access different IP Cameras.
To Next Page
Loading...