December 2001 List of Machine Parameters 4 – 51
MP7237 Displaying and resetting the operating times PLC
RUN
6 – 329
MP7237.0 Display PLC operating times
Input: Bits 0 to 7 represent PLC operating times 1 to 8
0: Do not display
1: Display
MP7237.1 Resetting PLC operating times with the code number
857282
Input: Bits 0 to 7 represent PLC operating times 1 to 8
0: Do not reset
1: Reset
MP7237.2 Resetting NC operating times with the code number
857282
Input: Bit 0 – No function
Bit 1 – “Machine on” operating time
Bit 2 – “Program run” operating time
0: Do not reset
1: Reset
MP7238.0-7 Dialog messages for PLC operating times 1 to 8
Input: 0 to 4095
Dialog no. from the file (OEM.SYS)
PLC
RUN
6 – 329
MP7245 Disabling auxiliary cycles
Input: 0: Auxiliary cycles disabled
1: Auxiliary cycles permitted
280 474-09
PLC
RUN
6 – 287
MP7246 Disabling paraxial positioning blocks
Input: 0: Paraxial positioning block enabled
1: Paraxial positioning block disabled
PLC
RUN
6 – 327
MP7260 Number of tools in the tool table
Input: 0 to 30 000
CN123 6 – 402
MP7261.0-3 Number of pockets in the tool magazine 1 to 4
Input: 0 to 254
CN123 6 – 402
MP7262 Maximum tool index number for indexed tools
Input: 0 to 9
280 474-03
CN123
6 – 417
MP7263 Hiding/showing the POCKET TABLE soft key
Format: %x
Input: Bit 0 –
0: POCKET TABLE soft key is shown
1: POCKET TABLE soft key is hidden
280 474-04
CN123
6 – 402
MP7266 Elements of the tool table
Input: 0: No display
1 to 99: Position in the tool table
CN123 6 – 402
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
