4 – 52 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP7267 Elements of the pocket table
Input: 0: No display
1 to 99: Position in the pocket table
CN123 6 – 404
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
MP7267.5 Tool name (TNAME)
MP7267.6 Comment on the tool (DOC)
MP7270 Feed-rate display in the MANUAL OPERATION and
ELECTRICAL HANDWHEEL operating modes
Input: 0: Display of feed rate by pressing
an axis direction key (axis-specific
feed rate from MP1020)
1: Display of the feed rate also before
pressing an axis direction key
(smallest value from MP1020 for all axes)
PLC, CN123
RUN
6 – 237
MP7280 Decimal character
Input: 0: Decimal comma
1: Decimal point
PLC, CN123
RUN
6 – 326
MP7281 Depiction of the NC program
Input: 0: All blocks completely
1: Current block all at once, others line by line
2: All blocks line by line; block when editing
all at once
280 476-03
PLC
RUN
6 – 245
MP7285 Tool length offset in the tool-axis position display
Input: 0: Tool length is not offset
1: Tool length is offset
PLC, CN123
RUN
6 – 231
MP7289 Position display step for the spindle
Input: 0: 0.1°
1: 0,05°
2: 0,01°
3: 0,005°
4: 0,001°
5: 0,0005°
6: 0,0001°
280 474-09
PLC, CN123
RUN
6 – 231
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
