5 – 12 HEIDENHAIN Technical Manual TNC 426, TNC 430
M 4120 -
4128
PLC positioning axis 1 to 9 active NC/
PLC
NC/
PLC
6 – 35
M 4130 Activation of spindle orientation, or spindle
orientation has been started with Module
9171
NC/
PLC
NC 6 – 205
M 4131 Activation of Q-parameter transfer to the
NC; data from D258, Q number from W516
PLC NC 7 – 22
M 4132 Activate datum shift from D528 to D544, or
call Module 9230
PLC NC 6 – 399
M 4133 Starting and stopping the free rotation
function
PLC NC 6 – 235
M 4134 Activation of a gear range and speed
through the PLC
PLC NC 6 – 189
M 4135 Strobe marker for selecting the traverse
range
PLC NC 6 – 23
M 4150 Operating mode: Manual operation NC NC –
M 4151 Operating mode: Electronic handwheel NC NC –
M 4152 Operating mode: Positioning with manual
data input
NC NC –
M 4153 Operating mode: Program run, single block NC NC –
M 4154 Operating mode: Program run, full sequence NC NC –
M 4155 Operating mode: Traversing the reference
marks
NC NC –
M 4156 MANUAL TRAVERSE soft key pressed NC NC 6 – 295
M 4157 Returning to the contour (APPROACH
POSITION) is active
NC NC 6 – 295
M 4158 Block scan active NC NC 6 – 295
M 4159 PLC editor: END key or soft key pressed NC NC/
PLC
6 – 317
M 4160 Pallet table selected NC NC 6 – 306
M 4161 M/S/T/Q transfer after block scan NC NC 6 – 297
M 4170 END PGM, M02 or M30 was executed NC NC 6 – 300
M 4172 1. PLC scan after power on NC NC –
M 4173 1. PLC scan after interruption of the PLC
program
NC NC –
M 4174 1. PLC scan after editing the MPs (MP edit
was exited and the MPs were altered)
NC NC –
M 4175 Program interruption, control-in-operation
symbol blinks
NC NC 6 – 240
M 4176 Control is in operation, control-in-operation
symbol is on or is blinking
NC NC 6 – 240
M 4177 Erasable error message is displayed NC NC 6 – 173
M 4178 Error message EMERGENCY STOP is
displayed
NC NC 6 – 173
M 4179 Control is shut down NC NC 280 474-15 6 – 249
Marker Description Set Reset SW Vers. Page
To Next Page
Loading...
