December 2001 Overview of Markers and Words 5 – 13
M 4180 Rapid traverse programmed (FMAX) NC NC 6 – 237
M 4181 NC program selected NC PLC 280 476-01 6 – 245
M 4182 AUTOSTART active NC NC 280 476-17 6 – 247
M 4183 Time from AUTOSTART expired NC NC 280 476-17 6 – 247
M 4200 Overflow during multiplication NC PLC 7 – 116,
7 – 130,
7 – 159
M 4201 Division by 0 NC PLC 7 – 117,
7 – 130,
7 – 159
M 4202 Incorrectly executed modulo NC PLC 7 – 118,
7 – 130,
7 – 159
M 4203 Error status for PLC module NC NC/
PLC
7 – 130,
7 – 159
M 4204 Reserved for errors that the PLC
programmer would like to catch
NC NC 7 – 159
M 4220 Error from PET table with F stop active NC NC 280 474-15 6 – 278
M 4221 Error from PET table with NC stop active NC NC 280 474-15 6 – 278
M 4222 Error from PET table with EM. STOP active NC NC 280 474-15 6 – 278
M 4230 NC start via LSV2 NC NC 280 476-05 6 – 344
M 4231 NC stop via LSV2 NC NC 280 476-05 6 – 344
M 4300 to
4315
Value from MP4310.0 NC NC 7 – 36
M 4316 to
4331
Value from MP4310.1 NC NC 7 – 36
M 4332 to
4347
Value from MP4310.2 NC NC 7 – 36
M 4348 to
4363
Value from MP4310.3 NC NC 7 – 36
M 4364 to
4379
Value from MP4310.4 NC NC 7 – 36
M 4380 to
4395
Value from MP4310.5 NC NC 7 – 36
M 4396 to
M4411
Value from MP4310.6 NC NC 7 – 36
M 4520 Additional T code (P code) follows with
TOOL CALL
NC NC 6 – 425,
6 – 440
M 4521 Tool number zero programmed NC NC 6 – 424
M 4522 Tool with pocket number programmed is in
effect with MP7480.0 = 3 or 4 and TOOL
CALL
NC NC 6 – 425
M 4523 Tool without pocket number programmed is
in effect with MP7480.0 = 3 or 4 and TOOL
CALL
NC NC 6 – 425
Marker Description Set Reset SW Vers. Page
To Next Page
Loading...
