Users Manual for T4000+ Series 27
Timeserver, or the Timeserver is
currently available
network administrator.
No label size
The size of the label is not defined
in the programming.
Check programming.
Table 7 Error Messages and Fault Corrections Part 1
Error message Cause Comment
Head open
Print head not locked Lock print head.
Head too hot
Print head is overheated After pausing the print job will
be continued automatically. If
the fault recurs repeatedly,
reduce the heat level or the
print speed via software.
Read error
Read error when reading from the
memory card
Check data of the card.
Backup data, reformat card.
Cutter jammed
The cutter is unable to cut the
labels but is able to return into its
home position
Press the cancel key. Change
material.
Card full
No more data can be stored on
the memory card.
Replace card.
Cutter cannot return into its home
position and stays in an undefined
position
Switch off the printer. Remove
material. Switch on the printer.
Restart print job. Change
material.
Cutter blocked
No cutter function Switch the printer off and then
on. If error recurs call service.
Out of label roll Load labels.
Out of paper
Error in the paper feed Check paper feed.
Protocol error
Printer has received an unknown
or invalid command from the
computer.
Press the pause key to skip the
command or press the cancel
key to cancel the print job.
Buffer overflow
The input buffer memory is full
and the computer is still
transmitting data.
Use data transmission via
protocol (preferably RTS/CTS).
Write error
Hardware error Repeat the write process,
reformat card.
Write protected
PC card write protection is
activated.
Deactivate the write protection.
Font not found
Error with the selected download
font.
Cancel current print job,
change font.
Invalid setup
Error in the configuration memory Re-configure printer. If error
recurs call service.
Voltage error
Hardware error Switch the printer off and then
on. If error recurs call service.
It is shown which voltage has
failed. Pleae note
Memory overflow
Current print job contains too
much information, e.g. selected
font, large graphics
Cancel current print job.
Reduce amount of data to be
printed.
Structural error
Error in the file list of the memory
card, data access is uncertain.
Format memory card.
Unknown card
Card not formatted. Type of card
not supported.
Format card, use different type
of card.
USB error
Device stalled
A USB device has been detected,
but it is not working
Do not use the USB device.
USB error
Too much current
The USB device consumes too
much current
Do not use the USB device.
USB error
Unknown device
Failure to detect USB device Do not use the USB device .
Table 7 Error Messages and Fault Corrections Part 2
To Previous Page
Loading...
