Users Manual for T4000+ Series 7
2. Safety and Environment
Read these operating instructions carefully before using the label printer for the first time. The
operating instructions describe all of the functions of the label printer during operation. The
available functions depend on the version used for a specific job.
2.1. Safety instructions
• The device is configured for voltages of 100 to 240 V AC. It only has to be plugged into a
grounded socket.
• Only connect the device to other devices which have a protective low voltage.
• Switch off all affected devices (computer, printer, accessories) before connecting or
disconnecting.
• The device may only be used in a dry environment, do not expose it to moisture (sprays of
water, mists, etc.).
• Do not use the device in an explosive atmosphere.
• Do not use the device close to high-voltage power lines.
• If the device is operated with the cover open, ensure that people‘s clothing, hair, jewelry etc.
do not come into contact with the exposed rotating parts.
• The device or parts of it can become hot while printing. Do not touch during operation, and
allow to cool down before changing material and before disassembly.
• Risk of crushing when closing the cover. Touch the cover at the outside only. Do not reach
into the swivel range of the cover.
• Perform only those actions described in this operating manual. Work going beyond this may
only be performed by trained personnel or service technicians.
• Unauthorized interference with electronic modules or their software can cause malfunctions.
• Other unauthorized work on or modifications to the device can also endanger operational
safety.
• Always have service work done in a qualified workshop, where the personnel have the
technical knowledge and tools required to do the necessary work.
• There are various warning stickers on the device. They draw your attention to dangers.
Warning stickers must therefore not be removed, as then you and other people cannot be
aware of dangers and may be injured.
•
The maximum sound pressure level is less than 70 dB(A).
DANGER!
Danger to life and limb from power supply.
► Do not open the device casing.
To Next Page
Loading...
