Hercules 10 - Setup Programs; How to Go into Full Mode Setting; How to Go into Part 1 Mode Setting; How to Go into Part 2 Mode Setting

10 Zone LED Alarm Panel - Engineering Manual
21
6.2 - Setup Programs
The panel has three programs: 1 = Program Full, 2 = Program Part1, 3 = Program Part2.
Each program can set all parameters independent, these are 1 = Zone Function, 2 = Exit Mode,
3 = Exit Time, 4 = Entry Time.
Zones can also be assigned different functions in different programs. Refer to the following
diagram for the programming structure.
6.2.1 - How to go into Full mode Setting
· Under Engineer mode.
· Press to Select Setup Programs.
· Press to accept and go into Program Full.
6.2.2 - How to go into Part 1 mode Setting
· Under Engineer mode.
· Press to Select Setup Programs.
· Press to accept and go into Program Part 1.
6.2.3 - How to go into Part 2 mode Setting
· Under Engineer mode.
· Press to Select Setup Programs.
· Press to accept and go into Program Part 2.
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
E
S
T
1
1
1
&
&&
&
O IMT