10 Zone LED Alarm Panel - Engineering Manual
30
6.6 - Setup system
The Setup system contains five parts. They are listed as follow:
1 = Flags1, 2 = Flags2, 3 = Bell Time, 4 = Rearm count, 5 = Bell delay time
6.6.1 - How to Setup System Flags
The System Flags are divided into Flags1, 2.
Flag1 – Options
There are eight options under Flag1 which are described below:
2=RKP PA, 3=Engineer Reset, 4=PA user Reset, 5=Fire user Reset, 6=Bell in Fire,
7=Disable Bell Tamper, 8=lock Engineer Code, 9=Exit Walk Test
RKP PA
When this flag is set to ON, the keypad’s PA function is enabled.
Engineer Reset
When this flag is set to ON, an engineer code must be entered to reset the system after
Tamper, PA or Fire alarm. When the flag is set to OFF the system can be reset by the user.
PA user Reset
When this flag is set to ON, it permits the user to reset the system after a PA alarm, by
pressing user code. The user can reset the system even if the Engineer Reset flag is set to
ON.
Fire user Reset
When this flag is set to ON, it permits user to reset the system after a Fire alarm by pressing
user code. The user can reset the system even if the Engineer Reset flag is set to ON.
Bell in Fire
When this flag is set to ON, the external siren Bell box will sound On/two seconds off /two
seconds during the fire alarm.
Disable Bell Tamper
When this flag is set to ON, when the Bell Tamper is trigger in FULL, Part1, Part2 mode the
alarm system will not process it.
Lock Engineer Code
When this flag is set to ON, System cannot change the engineer code in manager menu.
Exit Walk Test
When this flag is set to ON,
it will automatically return to next option after 20 minutes
.
To Next Page
Loading...