Hercules 10 - How to Restore to Factory Value Using Menu; View Event Log

10 Zone LED Alarm Panel - Engineering Manual
35
6.6.5 - How to Restore to factory value using menu
You will change the value of all parameters to factory default value when you set it.
CAUTION: All configurations of the panel are reset to reset to factory default conditions.
To default to factory settings:
·
··
· Under Engineer mode to top of menu.
LED 1~10 is flashing.
· Press twice within 2 second.
All system setting returns to factory default.
NOTE: if Lock Engineer flag is ON, Engineer Code can not reset to factory default
6.7 - View Event Log
After selecting Alarm Log the zone, PA and Tamper LED’s will show the latest event
A flashing LED indicates the zone that was first activated.
Any other LED lit was activated after the first event but before system unset.
· Under Engineer mode.
· Press to select view alarm event.
LED 1flashing indicate Zone 1 is triggered first.
TAMPER is triggered after Zone 1
· Press to leave view alarm log menu.
How to clear all alarm events?
· Under Engineer code
· Press to select view alarm event.
· Press to clear all alarm events.
All LEDs will go out and the panel will emit
a confirm sound to indicate clear all alarm event.
· Press to leave view alarm log menu.
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Acknowledge
R ES TE
R ES TE
9
O IMT
&
&&
&
&
&&
&