HERMOS LFM LP Reader - Protocol Change Allowed

Protocol description ASCII, SECS/HSMS
Customer manual
Version 1.2
LFM LP Reader 15.01.2019
Page 108 of 119
HERMOS AG
Gartenstrasse 19 Tel. +49(9279) 991-0
D-95490 Mistelgau Fax. +49(9279) 991-100
98
0x62
Protocol change allowed
This parameter can be used to allow a
detected protocol change.
This will then set the new default protocol and
restart the device.
If the protocol change is suppressed, no
automatic change takes place. If the protocol
change is suppressed, no automatic change
takes place.
0 … protocol change not allowed
1 … protocol change allowed
Default : 1
99
0x63
Customer mode
Special customer parameter settings that differ
from the basic settings.
Several parameter values are set by a
customer code.
The following parameters are defined:
0 … device version according to SEMI E99-
0303
Par. 37 = 2
Par. 42 = 0
Par. 43 = 16
Par. 44 = 1
Par. 45 = 0
3 … device version before SEMI E99-0303
Par. 37 = 1
Par. 42 = 0
Par. 43 = 8
Par. 44 = 0
Par. 45 = 0
4 … device version without MID
Par. 37 = 0
Par. 42 = 0
Par. 43 = 0
Par. 44 = 1
Par. 45 = 0
Default : 0