Protocol description ASCII, SECS/HSMS
Customer manual
Version 1.2
LFM LP Reader 15.01.2019
Page 30 of 119
HERMOS AG
Gartenstrasse 19 Tel. +49(9279) 991-0
D-95490 Mistelgau Fax. +49(9279) 991-100
3. An antenna must be properly connected to the reading device. If the antenna has not yet been
tuned (->Status LEDs), then the automatic tuning must be carried out.
4. A transponder must be within the reading and writing ranges of the connected antenna.
5. After startup the reader works in operation mode.
The serial interface parameters
The following settings of the serial interfaces are set on delivery. The baud rate can be changed in the in
the SECS protocol (->Parameter 0x01). If you want to change the baud rate in the ASCII protocol, then
please contact the manufacturer HERMOS.
ASCII: Even
SECS/HSMS: None
To Next Page
Loading...