Hettich MIKRO 185 - Backlighting of the Display

EN
28/38 Rev. 02 / 11.2022 AB1203EN_SA
20.5 Backlighting of the display
To save energy, it can be set that, after a centrifugation run, the backlighting of the display switches off after 2
minutes.
With the rotor at a standstill, this can be set as follows:
The procedure can be aborted at any time by pressing the
STOP
OPEN
key. In this case, the settings are not stored.
SELECT
 Press and hold the button for eight
seconds.
t/min:s RPM >RCF<

SELECT
 Press the key until the following is
displayed.
t/min:s RPM >RCF<

START
PULSE
 Press the key.
t/min:s RPM >RCF< t/min:s RPM >RCF<

SELECT
 Press the key until one of the following is
displayed:
Power save : Automatic shutdown of the
backlighting.
off : Automatic shutdown deactivated.
on : Automatic shutdown activated.
t/min:s RPM >RCF< t/min:s RPM >RCF<

t
 With the keys, set off or on.
t/min:s RPM >RCF< t/min:s RPM >RCF<

START
PULSE
 Press the button to save the setting.
t/min:s RPM >RCF<
t/min:s RPM >RCF<

STOP
OPEN
 Press the key once to exit the "
Settings"
menu or press twice to exit the "
MACHINE MENU
".
t/min:s RPM >RCF<
Example:
t/min:s RPM >RCF<