Hettich MIKRO 185 - Querying the Hours of Operation and the Number of Centrifugation Runs

EN
AB1203EN_SA Rev. 02 / 11.2022 29/38
20.6 Querying the hours of operation and the number of centrifugation runs
The hours of operation are divided into internal and external hours of operation.
Internal hours of operation: Total time the device was switched on.
External hours of operation: Total time of the previous centrifugation runs.
With the rotor at a standstill, the query can proceed as follows:
The procedure can be aborted at any time by pressing the
STOP
OPEN
key.
SELECT
 Press and hold the button for eight
seconds.
t/min:s RPM >RCF<

SELECT
 Press the key until the following is
displayed.
t/min:s RPM >RCF<

START
PULSE
 Press the key.
TimeExt : External hours of operation.
Example:
t/min:s RPM >RCF<

SELECT
 Press the key.
TimeInt : Internal hours of operation.
Example:
t/min:s RPM >RCF<

SELECT
 Press the key.
Starts : Number of all centrifugation runs.
Example:
t/min:s RPM >RCF<

STOP
OPEN
 Press the key twice to exit the "
Time &
Cycles"
menu or press three times to exit the "
MACHINE MENU
".
t/min:s RPM >RCF<
Example:
t/min:s RPM >RCF<