10/34
4 Error messages
The error message will be indicated in the speed display of the front panel.
e.g. :
RPM x 100
START
STOP
t
Fehlermeldung / Error indication
4.1 MAINS RESET
• Switch off the mains switch.
• Wait at least for 10 seconds and then switch on the mains switch again.
4.2 Brief description
Display. Fault Brief description Page
- 1 - Tacho error Tacho pulses break down during the run 11
- 2 - System reset Mains interrupt 11
- 3 - Imbalance Imbalance on the motor axis 11
- 4 - Communication Communication error 12
- 5 - Overload Fault in the motor or the motor control 12
- 6 - Overvoltage Mains is out of the toleranc 12
- 8 - Undervoltage Mains is out of the toleranz 13
- 9 - overtemperature Overtemperature switch in the motor release 13
Versions Error No indication in the speed display
Machine version misadjusted.
16
- c - Controller-Watchdog Fault in power board 14
- d - Lid lock error Fault in lid lock system 14
- E - Short circuit Short circuit in power board 14
- F - Rotor code No rotor code signals 15
rot… New rotor identified New rotor was installed 15
To Next Page
Loading...
