9/34
3 Troubleshooting procedures
• Fuses in installation in which centrifuge is installed are intact.
• Mains input fuses of centrifuge are intact.
• Supply voltage present at (see circuit diagram):
− Connecting cable
− Appliance plug
− Mains switch
− Power board A1, plug S402L and S402N
• Look for the displayed error code in the chapter "Error messages".
• Remedy the error according to the instructions.
• Carry out a functional check after every repair and whenever a component is
replaced, see chapter "Functional check after a repair".
To Next Page
Loading...
