V30 GNSS RTK System Manual
19
Collection
interval
F2
Single press F2 to set collectioninterval
to be 1s,5s,10s
collection
Double click F2
Double click F2 to start collecting
static data
Confirm setting
power button
Then the receiver will speak out its
current work mode, data link, radio
transmit power, channel; meanwhile
the power led will flash to hints its
power status
Auto-set base
F1+Power
button
receiver
Press F
buttonat the same time to turn on the
receiver until hearing “Dingdong”.
Then the receiver speak out its
current status.
Reset receiver
Long press F1 Reset the mother board
original settings
Long press F2
Then it will automatically rectify,
correct and reset to the original
settings.
work status
Single click any
non-settings
status
For static mode :
out“static”, collection interval,
elevation angel; at
the same time the
power led flashing times hints the
power status and the satellites led
flashing times hints tracked satellites
number
For base in external mode: receiver