General Operations
28
from the controller to PC by copying.
Reset Receiver
Long press F1 button for more than 6 seconds to reset the
mother board.
Warning: reset receiver will make the next
tracking satellite time longer while
needs users to set receiver work
mode again.
Module checking
Long press F2 for more than 6 seconds to check the
module in current work mode.
Format Receiver
Format V30 receiver by Hi-Target V30 Receiver
Management Software:
Connect V30 with PC by serial port of Y data cable
Turn on V30 receiver
Choose right serial port and open port
After connecting successfully as figure 4-2: the S/N will be
showed in the below
Click “Format/Delete All” to complete format receiver.
After this operation, all current data will be deleted forever.
To Next Page
Loading...
