V30 GNSS RTK System Manual
49
Fast Operation Guide
Rover or base mode with built-in GPRS or 3G module.
1. Set base/rover
Double click F1 with the voice prompt “base”, “rover”
and “ static” to choose the working mode you need, press
power button to confirm the setting.
2. Set GSM data link
Double click F2, then choose GSM mode from
UHF,GSM and external radio then click the power button to
confirm.
3. GPRS setting
There are two ways. One is using the Controller with
Hi-RTK software, please refer to Hi-RTK manual to find more
details on how to do the settings. The other way is by using the
management software. Connecting the receiver to PC with Y
type cable, then open the management software of V30
receiver, choose the serial port and then open it. After the
instrument is connected, do the settings through the
management software of V30 receiver. Refer to figure 5-6.
To Next Page
Loading...
