V30 GNSS RTK System Manual
69
Eight-pin Port: to connect with the eight-pin port of V30
receiver
USB Port: to connect with PC USB for data downloading
from V30
Serial Port: to connect with PC serial port for V30
firmware upgrade, receiver settings, manage static data file,
set radio parameters, etc.
Warning: 1. When connecting plugs of all the
V30 GNSS RTK system,( See below) please
make sure to make two red points aligned , one
on plug and the other in the V30 receiver socket,
otherwise, it will bring damage both to socket
and plug.
2. When finish your work, please take out of plug
directly. Don’t spin the plug.
3. In order to protect the plug, please store the
cable in a good status and places without
extruding.
Plug red dot
Socket red dot
To Next Page
Loading...
