Setup and Installation Procedures Page 2-8
PLT-02496, Version: 1.0 November 2015
2.7 Printer Power
To connect power to the printer, follow this procedure.
Note: Do not connect the printer’s USB cable until prompted during the printer driver installation.
1. Plug the power cable into the back of the printer.
2. Plug the wall power cable into a standard 100-240VAC power outlet.
3. Press the printer’s ON/OFF button to power on the printer.
Note: The printer powers down during the “sleep time” but automatically powers up when a
print job is sent.
Receptor for power cable
Printer ON/Off Button
Printer Back
Printer Front
To Next Page
Loading...
