November 2015 PLT-02496, Version: 1.0
Printing Preferences Page 3-15
3.6 Lamination Tab
These options allow control of the printer's lamination process. When no laminator is detected, the
lamination tab is active but all functions are disabled.
Field Description
Lamination Position
Use this control to adjust the horizontal position of the laminate. Only the horizontal
position needs adjustment. Default is 0.
To adjust the position, click on the horizontal adjustment arrows. The adjustment
arrows point in the direction the patch will move on the card.
The maximum horizontal value is 100 Pixels (10 Pixels = 0.03 [0.8mm]).
Lamination Speed
Transfer Dwell Time: Adjust this control for the throughput speed of a card in
seconds per inch, default is 2.0 seconds per inch.
• Maximum Limit - 4.9 seconds per inch
• Minimum Limit - 0.8 seconds per inch
Lamination Side
Specify the side(s) of the card to laminate:
• No Lamination
•Front
•Back
•Both
To Next Page
Loading...
