HID Fargo DTC5500LMX - Additional Printer Specific Tools

Troubleshooting Page 5-12
PLT-02496, Version: 1.0 November 2015
5.2.4.1 Additional Printer Specific Tools
Label Description
INFO
Printer Type
Firmware Version
IP Address
Flipper
Lamination
Magnetics
E-Card
Password
Card count
TEST PRINTS
Color Photo: Select this choice to print a color card to test communication and integrity.
Alignment: Select this choice to print a card used to align the print image on the card.
Settings: Select this choice to print a card with the Advanced settings.
Resin: Select this choice to print a RESIN test card.
Rewritable: Select this choice to ERASE the Rewritable card.
Magnetic: Select this choice to test Magnetic encoding (Hi-Co only)
Lamination: Select this choice to laminate a test card.
Hopper Select Select the hopper to input cards. Applies to dual-hopper printers.
ToolBox
Clean Printer: Select this choice to run the clean printer routine.
Clean Laminator: Select this choice to run the clean laminator routine.
Calibrate Mag: Select this choice to calibrate the Magnetic Sensor.
Calibrate Rib Sensor: Select this choice to calibrate the ribbon sensor.
Network: Select this to choice configure network options
Language Select this choice to change the Printer Displayed Language.
Exit Select this choice to exit the Printer Tool options.