16 - 48
2.7 INSTALLATION
DDS models are conceived for a direct installation in the ambience to dehumidify.
DCS models are conceived for a ducted installation in a technical adjacent room, thus are supplied without the front
cover (see dimensional drawings on page 7). DCS are predisposed for the connection with supply and recover grilles
(optional), or other alternative ducting to permit the suction and supply of the air into the room that needs to be
dehumidified.
2.1 ELECTRICAL CIRCUITS
The electrical panel is realized and wired according to the direction EN 60204-1. The control circuit is protected by the apposite
magneto-thermal switch.
All the drives at distance are realized with low-tension signals, supplied by an insulation transformer.
To stop the group, do not remove tension through the protection at the basis of the unit: this
organ has to be used to section the whole unit during maintenance. To turn it off, use the user
terminal.
To Next Page
Loading...
