21 - 48
3.4 ALARMS MENU
This menu is accessible only if there is an alarm on the unit and it allows to display the active alarm and, if possible, to reset it.
On the left you see the screen which allows to chose whether to display the alarm or to reset it.
- press EXIT to exit and come back to tha main screen
- press UP and DOWN to select what to do
- press OK to confirm the choice and to shift to the further screen
On the left you see an example of alarm display; in the low part you see the equipment in alarm
or the type of alarm; in this example, electrical heaters are in alarm.
This screen is compulsory for the assistance in case of alarms
- press EXIT to exit and come back to the main screen
On the left you see the screen for reset the alarms. Only some alarms can be inactivated and you can proceed by paying attention to
the fact that the cause of the alarm has not been solved and the alarm could appear again.
- Pressing OK for 3 seconds the alarm is reset and you come back to the main screen
- Press EXIT to exit and come back to the alarm menu
3.5 UNIT STATUS MENU
This menu is always accessible and allows to display all the information regarding the unit status, specifically the following lines:
fan, compressor, water valve, electrical heater, ambient temperature, ambient humidity, evaporation temperature, defrost
temperature, water temperature, dehumidification request, heating request.
The water valve and the electrical heaters are options so they could also be absent: in this case, on the corresponding line, some
strokes may appear.
On the left you see the unit status screen: in this case we see that the fan is functioning at the
medium speed, the compressor is on, the water valve is present and is off, as it is for the
electrical heaters.
press UP and DOWN to see the other lines
press EXIT to exit and come back to the main screen
To Next Page
Loading...
