EasyManua.ls Logo

Hidrostal A2Q - Special hazards; Mechanical hazards

Default Icon
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety requirements | 2
Hidrostal AG 11 / 49
In addition to the personal protective equipment specified in these operating
instructions, also observe the warnings located in the work area.
2.6 Special hazards
The following section indicates residual risks determined by a risk
assessment.
The safety instructions listed here and the warnings in the following
chapters of these instructions must be observed in order to reduce health
hazards and avoid dangerous situations.
2.6.1 Mechanical hazards
WARNING
Suspended loads.
Suspension points weakened by corrosion and/or mechanical stress.
Risk of fatal injury!
Use suitable, undamaged hoisting equipment only.
If there is a suspicion of weakened suspension points, secure the load
with suitable sling gear.
Only move loads under supervision.
Never stand below suspended loads.
Before leaving the work area: bring the load to the ground.
WARNING
Tipping loads.
Risk of severe injury!
Always sufficiently secure components against tipping.
Use suitable, undamaged hoisting equipment only.
Only move loads under supervision.
CAUTION
Sharp edges on the edge and inside the pump chamber.
Risk of injury!
Proceed carefully when working in the vicinity of sharp edges.
Wear safety gloves.

Table of Contents