Faults | 9
Hidrostal AG 41 / 49
9 Faults
The following chapter describes possible causes for malfunctions and what
needs to be done to correct them. If malfunctions occur more frequently,
shorten maintenance intervals according to actual load. If malfunctions
cannot be corrected by the following information, contact the manufacturer
or service partner, see Imprint [▶2].
9.1 Safety
Electrical system
DANGER
Contact with live parts.
Risk of fatal injury!
• Before starting work, switch off the electrical supply and secure against
switching back on.
Secure against switching on
WARNING
Unauthorised switching on of the energy supply.
Risk of severe injury!
• Make sure that the energy supply cannot be switched on if there are
persons in the danger zone.
In the event of faults The following fundamentally applies:
1. Push the emergency STOP immediately for faults that represent an
immediate danger to persons or property.
2. Turn off system and protect against restart or an automatic switch-on!
3. Immediately inform the supervisors at the working site about the fault.
4. Determine the cause of the fault.
5. Depending on the type of malfunction, either have the malfunction
rectified by authorised qualified personnel or rectify it yourself.
NOTE
The malfunction table below provides you with information regarding who is
authorised to troubleshoot the malfunction.
To Next Page
Loading...