Hidrostal A2Q - General Information; Information about these instructions; Explanation of symbols

General information | 1
Hidrostal AG 5 / 49
1 General information
1.1 Information about these instructions
Target group The target group of these operating instructions is the pump operating
company once the system, in which the pump is fitted, has been handed
over by the system manufacturer to the operating company in ready-for-use
condition.
The selection of the suitable pump, the safe and correct integration into the
system, the description of the operation, the installation and commissioning
are the system manufacturer's responsibility and are NOT covered in these
operating instructions.
How to use these operating
instructions
These operating instructions contribute to the safe and efficient handling of
the machine. The fundamental prerequisite for safe working is the
adherence to all safety information, warnings and operating instructions
given in the manual.
Reading obligation Before starting any task, personnel must carefully read and understand this
manual.
Storage location These instructions are part of the machine and must be stored in an easily
accessible location for personnel to consult before starting work.
Resale If the machine is sold or transferred, the operating instructions must also be
passed on to the new owner.
Other applicable
documents, regulations
and directives
Besides these operating instructions, the instructions and information as well
as the signs on the machine also apply. Any advice on technical
modifications must be attached to these instructions. Furthermore, the local
accident prevention regulations and general safety regulations for the
application range of the machine apply.
Illustrations in these
instructions
Illustrations in these instructions are provided for general understanding and
may differ from the actual design of the machine.
Loss of the operating
instructions
If these operating instructions are lost, please order replacement
immediately (delivery against a nominal charge). Contact data see Imprint
[▶2].
1.2 Explanation of symbols
Symbols are used to denote safety notes and warning messages in these
instructions. Signal words are found at the start of the safety notes and
warning messages and are used to express the severity of the hazard.
Safety instructions must be observed and proper care must be taken to
avoid accidents or injury and damage to property.
DANGER
... indicates an imminent dangerous situation that will result in death or
serious injuries if not prevented.