Thermal Monocular User Manual
5
Chapter 2 Preparation
2.1 Connect Device
Before You Start
Turn on the device after connecting it to your PC, and keep the device on for 10 to 15 seconds
before other operations.
Steps
1. Lift the cable interface cover.
2. Connect the device and power adapter with a Type-C cable to power on the device.
Alternatively, connect the device and PC to export files.
2.2 Install Battery
2.2.1 Battery Instruction
● Remove the battery from the battery compartment if the device is not used for a long time.
● The battery charger is not included in the package. Please purchase it by yourself.
● If you are using rechargeable battery, charge it for more than 5 hours before first use.
● The external removable battery type is 18650, and the battery size should be 19.2 mm × 70 mm.
The nominal voltage and capacity are 3.6 VDC/3200 mAh.
● The built-in battery type is lithium battery, and the battery size should be 6.8 mm × 2.1 mm. The
nominal voltage is 3 VDC, and the rated capacity is 3 mAh.
2.2.2 Battery Installation
Insert the battery into the battery compartment.
Steps
1. Press and push the battery compartment lock (shown in the black frame), rotate the battery
cover anticlockwise until the marks on the battery cover and the device are aligned, and
disassemble the battery cover.
To Next Page
Loading...
Need help?
General
