ID3000 Series Smart Code Reader User Manual
16
Select Obtain an IP address automatically to get an IP address of the PC automatically.
Or select Use the following IP address to set an IP address for the PC manually.
Figure 5-3 Set PC Network
5.4 Set Device Network
You can set and operate the device in the client software only when the device is in the same
network segment with the PC where the client software is installed.
Steps
1. Double click the client software to run it.
2. Click to find the device.
3. Right click the device to be connected.
4. Click Modify IP.
5. Set the IP address of the device in the same network segment with the PC.
To Next Page
Loading...
