ID3000 Series Smart Code Reader User Manual
77
Figure 8-60 Fins
8.7.11 SLMP
If SLMP is selected as the Communication Protocols, you can enable SLMP Enable and set related
parameters according to actual demands.
SLMP Dst Addr
It sets the IP address of the target PLC.
SLMP Dst Port
It sets the port number of the target PLC.
SLMP Data Base Addr
It sets the first address of the data area.
SLMP State Base Addr
It sets the first address of the status area.
SLMP Network Num
It sets the network No.
SLMP PLC Num
It sets the PLC No.
SLMP Module I/O Num
It sets the target module’s I/O number.
To Next Page
Loading...
