HikRobot ID3000 Series - 8.4 Signal Output Settings

ID3000 Series Smart Code Reader User Manual
50
Figure 8-33 Stop Trigger via Code Number
8.4 Signal Output Settings
8.4.1 Select Output Signal
The device’s output signal can control external devices like PLC, flashing light, etc. Click I/O Control
Settings → Output → Line Out Selector to select output signal.
Figure 8-34 Select Output Signal
8.4.2 Enable Line Inverter
The level inverter function allows the device to invert the electrical signal level of an I/O line, and
meets requirements of different devices for high or low electrical signal level.
You can go to I/O Control Settings → Output → Line Out Inverter to enable it.
Note
The Line Out Inverter function is disabled by default.