ID3000 Series Smart Code Reader User Manual
51
Figure 8-35 Enable Line Out Inverter
8.4.3 Set Event Source
The device supports outputting different trigger signals according to the event source you select.
Click I/O Control Settings → Output → Line Out Activation Event to select event source.
The device supports following event sources, including Off, Acquisition Start Active, Acquisition
Stop Active, Frame Burst Start Active, Frame Burst Stop Active, Exposure Start Active, Soft Trigger
Active, Hard Trigger Active, Counter Active, Timer Active, No Code Read, Read Success, and Light
Strobe Long.
Note
You need to set different parameters when selecting these event sources.
Figure 8-36 Set Event Source
To Next Page
Loading...
