ID3000 Series Smart Code Reader User Manual
70
8.7 Communication Settings
The communication protocol is used to transmit and output code reading result and image. The
communication protocol is related to the device modes. With various device modes, the device
supports different communication protocols and corresponding parameters.
When the device mode is Test or Raw, the device only supports Smart SDK protocol and no
parameter settings are required. While in Normal mode, the device supports Smart SDK, TCP Client,
TCP Server, Serial, FTP, Profinet, Melsec, Ethernet/IP, ModBus, Fins and SLMP communication
protocols, and you need to set corresponding parameters.
Note
The specific communication parameters may differ by device models and firmware.
8.7.1 Smart SDK
If Smart SDK is selected as the Communication Protocols, you can enable SmartSdk Protocol to
let the device output data via Smart SDK.
Encode JPG Flag
If enabled, the device will compress the image data.
Quantity of Jpg
You can enter a number (range: 50 to 99) to determine the compression quality
Figure 8-51 Smart SDK
8.7.2 TCP Client
The TCP includes TCP Server and TCP Client. If TCP Client is selected as the Communication
Protocols, you can enable TCP Protocol, and enter TCP Dst Addr and TCP Dst Port.
To Next Page
Loading...
