ID3000 Series Smart Code Reader User Manual
20
Chapter 7 Device Mode Settings
The device supports 3 types of operating modes, including Test, Normal, and Raw. You can select
different modes in live view window according to actual demands.
Note
●
Stopping the real-time acquisition is required before selecting modes.
●
You need to set device mode as Normal before specific device settings. Otherwise, the device
parameters may be different.
Figure 7-1 Select Device Mode
Table 7-1 Device Mode Description
It is used during device debugging. The device outputs images that are
acquired in real-time, and displays code information.
It is used during device normal operation. After reading code in image, the
device outputs image and code information.
You can click in the live view window to view images and the code reading effect. If the effect is
not very good, you can adjust the focus knob (the manual focus device only) or related parameters
in Image Settings area.
To Next Page
Loading...