ID3000 Series Smart Code Reader User Manual
87
Chapter 10 Device Maintenance
10.1 Update Firmware
The device supports updating firmware via the client software.
Note
●
Disconnect the device with client software.
●
Please use the firmware package of the corresponding device model for upgrading.
●
Do not power off the device or disconnect network during upgrading.
●
The device will reboot automatically after updating the firmware.
Select the device to be updated in the device list, right click the device, and click Firmware
Update. Click to select update file from local PC, and click Update to update firmware.
Note
You can also go to Tool → Firmware Updater to update firmware.
Figure 10-1 Update Firmware
10.2 Reboot Device
You can reboot the device via client software in 2 ways. Go to Config Management, and click Restart
Device. Or, you can select the device to be rebooted in the device list, right click the device, and
click Device Reset.
To Next Page
Loading...