HikRobot SC2000 Series - Page 14

SC2000 Series Vision Sensor User Manual
5
No.
Signal
I/O Signal Source
Description
16
DI_0
Line 0 signal line
Opto-isolated input
17
DI_1
Line 1 signal line
Opto-isolated input
Note
● You should refer to the table above and the label attached to the power and I/O cable to wire
the device.
● It is recommended to use the supplied 17-pin cable. The 6th, 7th, 14th, and 15th pin have been
made as RJ45 connector. The lines of other pins should be wired according to the actual
demands.