SC2000 Series Vision Sensor User Manual
18
7.1.5 Set Light Source
The device has 8 light bulbs, and you can go to Light Source Adjustment to set light direction, flash
mode, duration, delay, etc.
Direction
The device has 8 light bulbs, which are divided into up, down, left and right groups. You can
select UP, DOWN, LEFT and RIGHT to control respective light bulbs. By selecting ALL, you can
control all 8 light bulbs.
Enable
After enabling, the light bulbs you selected in Direction will turn on.
Flash Mode
It includes FLASH_STROBE and FLASH_LONG.
Duration
It refers to the duration time of light source.
Delay
The time when light source starts to light is later than that of exposure. It only takes effect when
selecting FLASH_STROBE as Flash Mode.
Advance
It refers to the time when light source starts to light is early than that of exposure.
Figure 7-2 Set Light Source
To Next Page
Loading...
