SC2000 Series Vision Sensor User Manual
39
In Image Display, click to display or not display edge 0 result, edge 1 result, edge line result
and detection area. Click to edit OK color, NG color, and transparency.
In OSD, enable Display Text to set text's color, front size, transparency, position X, and position Y.
7.4.8 L2L Measure
This tool is used to measure the distance between 2 lines. Generally, 2 lines are not parallel, and
this tool measures the average distance between 2 end points of one line to another line to
calculate the actual distance.
Input Method
It includes by line, by coordinate, and by point. If you select by line as input method, you need
to link the result of finding line. If you select by point as input method, you need to enter start
point, end point, and angle. If you select by coordinate as input method, you need to link the X
and Y coordinates of the line's start point, end point, and angle.
Figure 7-20 L2L Measure
Result Display
In display area, you can set different judge methods of image detection result, including angle,
distance, intersection point X, and intersection point Y.
In Judge Method, enable Judge by Angle, Judge by Distance, Judge by Intersection Point X, Judge
by Intersection Point Y, and enter corresponding range according to actual demands.
In Image Display, click to display or not display input line 1, input line 2 and intersection point.
Click to edit OK color, NG color, and transparency.
In OSD, enable Display Text to set text's color, front size, transparency, position X, and position Y.
To Next Page
Loading...
